Nagra VII Anniversary

Nagra VII Anniversary front recorder 2 tracks

The Nagra VII Anniversary Edition is the celebration of the 70th anniversary of the creation of the very first Nagra in 1951!

Electronically identical to a Nagra SEVEN, its front panel is totally new and built from a solid billet of aluminum. All the buttons are made of aluminum, including the potentiometer that are red and green as a testimony to the legendary Nagra IV-S.

The battery compartiment is also made from a solid block of aluminum.

The whole construction is super rugged and also a pleasure to feel.

Sonically the Nagra VII is the son of the Nagra V and Nagra VI that found their roots on the Nagra IV-S.

Its microphone preamplifiers are super transparent and silent. They can be compared to the best stand-alone microphone preamplifiers and can very well be connected to large membrane studio microphones.

The A/D and D/A are capable of 192 kHz / 24 bits that will make your musical recordings shine.

The Nagra VII is very intuitive and was designed with the sound engineer in mind. It takes a short training period to know how to operate it and be efficient in your work.

Having a dedicated recorder is a huge advantage as it allows the sound engineer to focus on sound and quality of the recording.

Book a demo

Audio inputs

The VII Anniversary offers two analog audio inputs and a single stereo digital input. It will record in PCM linear audio at sampling frequencies up to 192 kHz or in MPEG-1 layer II compressed audio formats if the compression option is installed. The inputs are equipped with traditional Nagra microphone preamplifiers for dynamic and phantom +48V microphones and offer a range of switchable sensitivities to accommodate all common microphones. AES-42 microphones can also be used as the recorder can supply the necessary 10V dc supply voltage on the AES input. The analog LINE input will accept up to +24dB, allowing it to be connected to a standard audio mixer in the field.

영상 재생하기

Get an insight into the Nagra Pro Audio

DISCOVER

Technical specification

RECORDING

Internal storage: Micro SD Flash memory card
Removable media: SD Flash memorycard
Disk format: FAT 16 / 32
Recording Method: Linear digital PCM, optional:MPEG 1 layer II
File type: 16 / 24 bit Broadcast Wave File BWF (WAV)
A/D & D/A: 24 Bit Sigma Delta
Bit rates: 32 kbits/s up to 384 kbits/sec
Tracks: 2 individual
Sampling Rate: 44.1, 48, 88.2, 96, 176.4 and 192kHz
Recording capacity: 1hr at 24 bit 48 kHz per GB of memory
Pre-recording buffer: Programmable
Display: Color LCD touchscreen
Level meters: On colour display

 

INPUTS

Digital input: XLR 3-pole / AES 42
Analogue inputs: 2 x XLR Microphone (Dynamic, +48V Phantom) / line
Mic. input sensitivity: 2.8, 10 and 40 mV/Pa selectable
Mic. input noise: Uin < 1µV (2.8 and 10 mV) @ 220Ω Uin < 1.6µV (40 mV)
Limiters: On microphone inputs
Line input sensitivity: Adjustable from -6 dBm up to +24 dBm for 0 dBFS recording
THD at 1 kHz: 2.8mV Mic <0.2%, 10mV Mic <0.1%, line <0.1% (measured on AES out)
Frequency response: Mic, 10Hz – 75 kHz (+0 – 3dB), Line 10 Hz – 90 kHz (+0 -1dB) (measured on AES out)
Signal-to-noise ratio: >110 dB ASA “A”
Input level adj. range: 42 dB Mic and from -6 to +24 dB Line
Input filters: LFA
Internal microphone: On the front panel
Crosstalk: Mic >70dB : Line > 110dB

 

OUTPUTS

Analogue line output: XLR 4.4V max (+15 dBm)
Crosstalk: >110 dB
Signal-to-noise ratio: >100 dB
Digital output: XLR AES-3 (24 bit or 16 bit)
THD+N: <0.004%
Frequency response: 10 Hz – 75 kHz (+0-3dB)
Headphones: Stereo 6.3mm (¼”) Jack 50 Ω
Internal speaker: 0.3W

 

OTHER

USB: Micro AB connector
M/S Decoder: Switchable
Ethernet: RJ 45

 

GENERAL

Dimensions: 165 x 175 x 65mm (W x D x H) (Incl. battery box)
Weight: 800g (1.75 lbs) (Incl. battery pack)
Power supply: External 15V
Power Consumption: Approximately 5W
Charge time: Approximately 3 hours
Battery life: >5 hours
Relative humidity: From 10% to 99% (non condensing)

 

Hear for yourself

Pro Audio contact
Nagra VII Anniversary front recorder 2 tracks
위로 위로